Bob,
If you are having trouble with both the KOI2 and the KPA100, it would seem
to me that the problem could very likely be at the computer end. Have you
tried a different computer? Have you checked the cable for continuity from
end to end on pins 2 and 3?
73,
Don W3FPR
> -----Original Message-----
>
> About a year ago, I installed my KPA-100 in an enclosure with KAT-100.
> Built a KIO2 for the QRP K2. Everything worked great for a while. KIO2
> quit working. Did lots of troubleshooting with advice from list
> but was not
> able to solve problem. Put KPA-100 back in K2 & my entire software worked
> fine until now! Will not work with Writelog, TRX Manager or Ham Radio
> Deluxe. Was able to display the frequency in HyperTerminal by using the
> Port - On- Display to send a test signal. Attempted to send command by
> HyperTerminal, and no-go. Also was able to get TRX Manager to display
> frequency when test signal was sent but would not track frequency or issue
> any commands.
>
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.8.1/28 - Release Date: 6/24/2005
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
