Hello,
I just installed the KIO2 option in my K2. All works well except that I now
obtain a lot of noise on my PSK31 waterfall display. The noise is effecting
the decoding of the PSK31 siganls. If I disconnect the serial cable from my
laptop, the noise disappears. In the instruction manual it stated to not
connect the sheild on the PC end of the KIO2 cable. I assume that this was
to isolate the K2 RF/DC ground from the PC ground? Any suggestions on
reducing the noise? Would putting a ferite choke on the cable be worth
while?
73s,
John - KI7V
K2 #3706
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
http://mailman.qth.net/mailman/listinfo/elecraftYou must subscribe to post.
Subscriber Info (Addr. Change, Unsub etc):
http://mailman.qth.net/subscribers.htmElecraft page:
http://www.elecraft.com
Locked
