KIO2 Not Working

[Elecraft mailing list]

Hello All,

I have a K2 with the KIO2 installed which has stopped working after I hooked it up to an Electaft 144mhz transverter, the transverter is working as I have used it with a K3. I have bought a new KIO3 kit, built and tested it as per the instructions however there is still no voltages at all. I suspect the K2, how would I prove / disprove this.

Thanks.


Best regards,
Richard Hubbard
Tel: [phone]
Mob: [phone]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Mike K8CN]

Richard,

What kind of cable did you use to connect the K2's KIO2 RS-232 port to the
transverter?  As Don, W3FPR has reminded us numerous times, one cannot use a
conventional RS-232 (straight thru serial) cable with the KIO2, but one must
instead make up the special cable described in the KIO2 manual.

Mike, K8CN



--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]