KPA-100 RFC 10 question

[oe9fwv]

hello,

in my KPA 100 manual there is  RFC 10 from the center pin of J2 to the
Ground pin. It is no more present in the Rev. E manual. Should I install it or
not?
I plan to mount the KPA 100 on top of the Kat100 in the EC2 housing.

73!
Werner

--
You cannot kill time without injuring eternity.-- Thoreau


Email powered by Pegasus Mail free at <http://www.pmail.com>
Homepage: <http://www.qsl.net/oe9fwv/>
Fone [phone]
Fax [phone]
Mobile [phone]
Elecraft K2 #5203


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-4]

Werner,

The new T/R switch design eliminates RFC10.  It was a source of trouble
because it could cause a 40 meter parasitic oscillation.  That problem
was usually noticed when operating with a KAT100.
Do not install RFC10 in the updated KPA100.

73,
Don W3FPR


Dr. Werner Furlan wrote:

> hello,
>
> in my KPA 100 manual there is  RFC 10 from the center pin of J2 to the
> Ground pin. It is no more present in the Rev. E manual. Should I install it or
> not?
> I plan to mount the KPA 100 on top of the Kat100 in the EC2 housing.
>
> 73!
> Werner
>
>  

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com