I've built the KPA 100 up to the alignment and installation steps and
made the resistance checks at J3+ and Q1 and Q2 collectors (all of which
are supposed to be greater than 10k). The instructions state that the
J3+ resistance may initially read 0 because a large electrolytic must
charge up and that it may take 20 seconds for the reading to stabilize.
My readings at J3+ and the Q1 collector never stabilize above 10k - they
start at 0, pop up to a value above 10k, then start decreasing
eventually ending around 1-2k. Is this okay?
Bob
K6VZT
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
