KPA100 -RF disappears

[Earl Ritchie-2]

My KPA100 has no RF out. Low power from the K2 is great. In checking I find RF as far as T1-5 then it stops.  The primary winding shows 300 ohms to ground from T1-5.  Does this teflon wire have that much resistance??
I guess I just dont understand why the power is not being transferred and would appreciate some help from others.  
Thank you, EArl VE3FBK
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Earl,

You may want to touch up the soldering on T1-5 and T1-4 first.  Either T1
has a broken primary wire or a bad solder connection.  The 300 ohms
resistance reading is proper with an open primary - R22 is in parallel with
the T1 primary winding.

73,
Don W3FPR

----- Original Message -----

My KPA100 has no RF out. Low power from the K2 is great. In checking I find
RF as far as T1-5 then it stops.  The primary winding shows 300 ohms to
ground from T1-5.  Does this teflon wire have that much resistance??
I guess I just dont understand why the power is not being transferred and
would appreciate some help from others.
Thank you, EArl VE3FBK



_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com