In preparation for the K60XV I just finished, I had to upgrade my
KPA100. It involved changing a few resistors, adding two jumpers, and
replacing the firmware. It's now shutting down when I go into tune
mode (with the KAT100). I smelled smoke, and R21 in the KAT100 shows
signs of overheating. I've pulled it back apart and looked for
shorts, wrong component values, or other problems, but found none.
Any ideas?
Jim K9YC
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
