KPA100 and RFC6, etc

[Jeff Kinzli]

Hey guys,

I'm working on KPA100, and at the step to install RFC6 and others. The board outlines and holes are for miniatures, but the only miniature I got was RFC9. Is it ok to bend the leads on the larger chokes to bend underneath the choke to make the holes? If I do this, the choke is about 0.25" off the board, is that ok?

Thanks,

-Jeff
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Ron D'Eau Claire-2]

See this info on the Elecraft web site.

<a href="http://www.elecraft.com/Apps/Builder%20Alert%20Installing%20Small%20Chokes%2">http://www.elecraft.com/Apps/Builder%20Alert%20Installing%20Small%20Chokes%2
0Rev%20B.pdf

Or, for a short URL:

http://tinyurl.com/yvm7vk


Ron AC7AC

-----Original Message-----
From: [hidden email]
[mailto:[hidden email]] On Behalf Of Jeff Kinzli
Sent: Monday, January 29, 2007 9:16 PM
To: [hidden email]
Subject: [Elecraft] KPA100 and RFC6, etc


Hey guys,

I'm working on KPA100, and at the step to install RFC6 and others. The board
outlines and holes are for miniatures, but the only miniature I got was
RFC9. Is it ok to bend the leads on the larger chokes to bend underneath the
choke to make the holes? If I do this, the choke is about 0.25" off the
board, is that ok?

Thanks,

-Jeff
_

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com