KPA100 build questions

[Mike Short]

I just bought a KPA100 that was originally purchased in 2002. It is
unassembled.
I ordered the firmware update, the KPA100UPKT and the shield upgrade. With
this I should be
able to build it up using the latest manual, yes? Would I not use the
component values in the latest
manual and go as if it was a recent amp?
 
Mike
AI4NS
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

Mike,

Yes, you can build it from the new manual with no problem.
The manual level should be either Rev E, or Rev D with the latest errata
sheet - the two are equivalent.

Be certain to do a complete inventory and put the extra parts aside so
you do not become confused with them.  You will have 2 pairs of 1.6 ohm
2 watt resistors - use only the ones with the reddish/brown body, the
light blue ones may be inductive.

73,
Don W3FPR

Mike Short wrote:

> I just bought a KPA100 that was originally purchased in 2002. It is
> unassembled.
> I ordered the firmware update, the KPA100UPKT and the shield upgrade. With
> this I should be
> able to build it up using the latest manual, yes? Would I not use the
> component values in the latest
> manual and go as if it was a recent amp?
>  
> Mike
> AI4NS

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com