Just finishing up a KPA 100 kit for my k2 and am running into a problem
I'm up to the "SWR Bridge Null Adjustment" on page 44. I set up the power to 5 watts (connected to a dummy load), and I get a "Hi Current" message followed by a reduced output reading. I checked the dummy load on an antenna analyzer and it's good. I feel something might be grounding out. I'm going to take the board off the heat sink but wanted to get this out there for any other ideas while I look. I did notice the fan comes on when I get that message.
thanks,
Roland in Stockton, Ca
k2 #3090
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
