Hi folks -
I am at page 21 of the KPA100 manual. I will be placing the am in my EC2
with the KAT100. My K2 is number 4667. On page 21 it begins to discuss
the internal ribbon cable connections.
My question is this. If I follow the KAP100 manual will I have to
reverse any of the steps from this point on if I will be using the amp
externally? Good advice on the reflector seems to be to build the amp,
remove the current K2 top with the battery and AT etc and check out all
amp functions as if the final product would be a K2/100.
I am just wondering if this means that any steps will have to be
reversed or "desoldered" when I get to the remote connection stage.
Thanks for any input in advance.
73/Tim NZ7C
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
