Hi guys
I have an otherwise perfectly performing K2 that has inoperative CAT.
CAT was working properly over the past 2 years so something has
changed. I do not remember trying it after performing the latest
KPA100 mod and firmware upgrade so it could have crept in there, but
I have ensured that there are no cold/bridge/bad solder joints there.
In investigating, there is very little (-0.2v) on pin 8 of u4.
Following the circuit backwards, I have nowhere near normal voltages
over d1-d8. I have verified that the diodes are all okay, no bridges
or poor solder connections.
Does this sound like the oscillator at X1 is not firing? Is there a
good way to know?
73
Neal Campbell K3NC
[hidden email]
telnet to our DX Spotting clusters at: dxc.k3nc.com, ports 12001 and 23
"Devoted to Dogs: How to be your dog's best owner"
Great Dog Book at www.abrohamneal.com
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
