All,
I'm debugging what appears to be a self-oscillation "issue," i.e.,
several smoked components, in my KPA100. Doing this I've discovered
that it's a minor annoyance to solder and unsolder the speaker wire to
get unencumbered access to the board. I know I can leave it unsoldered
till I'm all done, but just in case I'm doing this again at some point I
thought I'd make things easier for my future self. I imagine I'm not
the first to go through this and wonder if anyone has found a set of
connectors they'd recommend so that the speaker can simply be plugged
and unplugged. I'm thinking mid-wire connectors would make more sense
than on-board but I'm of course open to all ideas.
Thanks,
Mike ab3ap
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
