Thank you for the fast response.
In another email thread, I'm proposing a network interface for the K3
(with audio) that plugs into the same connector as the K-pod (but would
need an audio section as well for older KIO boards), which would make
the entire K-line network available; therefore (with some software
updates for management) much easier to remote without a computer to
manage the station.
Rick
On 2/21/2018 1:06 PM, Dick Dievendorff wrote:
> This is planned for the next utility rev. Static IP was just recently added to firmware.
>
> 73 de Dick, K6KR
>
>
> Sent from my iPhone
>
>> On Feb 21, 2018, at 12:37, Rick WA6NHC <
[hidden email]> wrote:
>>
>> Hello,
>>
>> I normally run the KAT500 and KPA500 utilities on the computer than manages my station.
>>
>> I'm awaiting the arrival of the KPA1500 but in the meantime I read the manual and download/installed the KPA1500 utility, which leads me to a request.
>>
>> In one of the next utility iterations, could it include a network interface made within the utility program so that instead of a serial port, the network connector could be used?
>>
>> Thank you,
>> Rick WA6NHC
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home:
http://mailman.qth.net/mailman/listinfo/elecraft>> Help:
http://mailman.qth.net/mmfaq.htm>> Post: mailto:
[hidden email]
>>
>> This list hosted by:
http://www.qsl.net>> Please help support this email list:
http://www.qsl.net/donate.html>> Message delivered to
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
