[KPA500] No power out in "OPER" mode

[Dave Johnson]

Larry

If you use ALC between your KPA500 and your transceiver, check to see if
there is a permanent output from the KPA500. U8 on the KPA500 control board
is a known issue where the wrong part was specified up to at least serial
573 (mine)...

The fix is to obtain the correct part and replace it. A work around is to
not use ALC.

73 Dave, G4AON
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html