I believe PWR SET in the CONFIG menu has to be set to 'Per band' for it
to save two power settings - one for barefoot, and one for amp
operation. It is on page 53 of the K3 Owners Manual.
Mike - KI0HA
On 12/24/2017 09:46, hawley, charles j jr wrote:
> I updated the KPA500 to 1.54 and went to o=Operate on the amp.
> The K3 displayed "Operate", but the K3 did not change the power to low drive power. I do doubt if it had anything to do with the update.
> Then I tried to set the power levels switching from Standby to Operate and back. Still no joy.
> Then I restored the K3 to an earlier configuration and all is well. Now the power switches from low power on Operate to high power on Standby.
> Is there some menu setting that can select whether that works or not?
> I could not find one.
> What could have happened to the K3 to keep that from working as advertised?
>
> Chuck Hawley
>
[hidden email]
> Amateur Radio, KE9UW
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
