Sometimes people select the wrong serial port # in the KPA Utility. If you
have several ports to choose from on the "Ports" tab, try each.
73 de Dick, K6KR
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of David Mitchell
Sent: Friday, March 08, 2013 4:49 AM
To:
[hidden email]
Subject: [Elecraft] KPA500 Serial Port Problem
I bought an KPA 500 this fall and just started using it because my antenna
was down from the hurricaine. I can't get the serial port to communicate
with my computer. I bought two of the UISB to serial cables with the FTDI
chipset, which I KNOW work because my Winkeyer uses one, and neither one
could find my amp. I then bought a two port PCI serial card and a
conventiional cable and could not connect using that setup, even though
Windows XP says that all the ports are working properly.
Any suggestions are appreciated. I might just have a bad serial board and
the amp should still be under warranty.
--
Dave WB2PJH
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html