I have 2 KRC2's, one is working correctly with my K3. The second one
used to work, but now just blinks the LED slowly, about 1 sec. rate,
when powered up. If I switch the OP/DL switch to DL the LED turns off.
I have no comms over the serial port with my computer. I'm using the
same setup as the one that works.
I tried to D/L new firmware, but it never finishes and the symptoms
never change. Is the PIC16F877 fried, or the serial interface chip
(MAX1406)?
Any suggestions on what to try?
Thanks,
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
