Ordered KRX3 in June 2007. Rcvd K3 s/n 453 Feb 08. Rcvd KRX3 kit June 19.
Completed KRX3 assy yesterday June 20.
Congrats to Elecraft for an excellent assembly manual. I only wish my
fingers were smaller to handle the 4-40 hardware in tight places but, it got
done.
I had one scare when I fired it up after doing the startup routine. I
enabled sub rx but got error mesage attempting VCO CAL in sub mode. I
discovered I needed to update DSP2 firmware to V1.88 first. After I did
that, the VCO CAL in sub and filter setup went smooth.
Thanks again Elecraft
Jim
K7EG
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
