nope,,,,, the jumper it is NOT between , as described in the manual ....
I sent this note to support :on July 16th,,,
the w4 jumper is NOT between the w4 jumper block and the Kio boards,,,,,
I kept looking to make certain i was looking at the w4
jumper....(which I was)
and you do need to take out the general coverage board to get access
to clip it ( w4) cleanly... it went right into # 44
bill
--------
And since it was contradictory to the instructions in the manual
i rechecked it a zillion times ... checked the schemo... then cut w4
For Ron I have attached a pix, which will get stripped by the
reflector for the crowd.
While there is a jumper located as described , W4 is just in front of
the connector.
bill
At 10:42 AM 8/25/2008, Ron D'Eau Claire wrote:
>Yep. The soldered jumper on the older boards is between the connector and
>the KIO3 board. There's an arrow and callout in Figure 39 in the KRX3 manual
>showing where it is.
>
>Early on Wayne moved it to a plug-in jumper in the connector because it was
>hard to get to the soldered jumper on the RF board. Besides, if one wanted
>to use the K3 with the KRX3 removed it's necessary to replace that jumper as
>described in the manual.
>
>Ron AC7AC
>
>-----Original Message-----
>
>It IS in the instructions that our older boards had a wire which
>needed to be cut....
>and that jumper is indeed partially hidden by the bandpass board,
>
>That jumper's location could be better identified in the instructions, as I
>recall it is to the rear of that jumper block, not in front of it .
>
>It went in fine and does work great.... still calmly awaiting the
>firmware to allow being able to split it off to another band.
>
>bill
>
>
>
>At 03:06 PM 8/24/2008, Jim Denneny wrote:
> >I could not get KRX3 or Main to RX after KRX3 install. After checks
> >and rechecks with Rene of Elecraft, we discovered the W4 jumper had not
> >been removed.
> >
> >Now here is the "gotcha". Manual shows jumper across two pins of a
> >connector. I saw none and moved on. My RF board is a Rev A. The
> >KBPF3 module mounts over the top of the RF board. Guess what? The
> >KBPF3 board covers the W4 jumper which is soldered to the RF board.
> >Cut the jumper and RX comes alive.
> >
> >I wish to thank Rene for his exemplary support. He called me on a
> >SUNDAY and spent hours on the phone sleuthing this problem. Do you
> >think K-I-Y would help you like that on Sunday?
> >
> >Jim
> >K7EG
>
>_______________________________________________
>Elecraft mailing list
>Post to:
[hidden email]
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft>
>Help:
http://mailman.qth.net/subscribers.htm>Elecraft web page:
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
