Fred,
Yes some of the computer cable connectors are too high. If you are wiring
for the Elecraft configuration, you can use the 2 pin computer type jumpers
(available from RS, Mouser, scrounged from your local computer dealer,
etc.). Even if you are not using the Elecraft pinout, many of the pins
still wire straight across (except for the Yaesu mic pinout). If you have
the tool and wire, wire-wrapping is a good option too.
73,
Don W3FPR
> -----Original Message-----
>
> Anyone have a source for short jumper plugs for the mic config header in
> the K2? I have some from a microprocessor project, however the part
> that goes on the pin is too long to fit between the front panel and
> control board. I'm hoping to avoid soldering jumpers to the header pins
> (which I already know isn't the easiest or prettiest of tasks).
>
> 73,
>
> Fred K6DGW
> Auburn CA CM98lw
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.8.13/47 - Release Date: 7/12/2005
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
