Jerry,
If you have previously set up your CW filters and BFOs- do not change them
(unless you find you want to later on). Do initially set up the SSB filters
and BFOs as indicated - that will get you up and running, Then refine the
BFOs (and filter widths) to your tastes, remembering that the FL1 BFO is the
one used for transmitting and that should be set to best match your voice
during transmit by listening on a separate receiver.
You can find some information on how to set up the filters on my website
www.qsl.net/w3fpr - look at the article on K2 Dial Calibration and you will
find the CAL FIL information in Step 3 of that article.
73,
Don W3FPR
----- Original Message -----
> Just finished installing the SSB adapter into my K2 (#4472) and on page 20
> step 3 it says to set up my filter exactly as shown in Table 3.
> My question is . Why do I have to change the ones for CW and CW reverse?
> I guess I just don't understand how these filters work. I plan to run
> mostly Digital modes, but will use Voice occasionally.
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
