KSB2 toroids (T1 & T2)

[Brian Mury-3]

I'm in the process of winding T1 and T2 for the KSB2.

The illustration shows that winding 1-2 is wound in the opposite
direction from 3-4. Is this correct? All of the toroids in the K2 have
1-2 and 3-4 in the same direction.

I only noticed this because in the K2 the green wire fit nicely in
between the windings of the red wire - if I do the KSB2 toroids the way
the manual shows, they don't fit in between but cross over on every
turn.


--
73, Brian
VE7NGR

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Mychael Morohovich]

Hi, Brian-

It is fine to allow the secondary windings of KSB2 T1,T2 to nest with their
respective primary windings. In other words, listen to your instincts and
wind them in the same direction. In this instance, the "sense" of the
primary in relation to its secondary is unimportant.

73,

Mychael AA3WF
K2 #1025


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com