I just finished my KSB2 and was ready to get it checked out with the mike, but I accidently put the 16 pin header on the wrong side of the Control Board. I was able to get it out but not without ruining it. Other than being more convenient to change mikes, any real need for the header? Do any of you dispense with the header and just wire to the pcb pads? I'd rather not wait for a replacement. I can allways install it later if I need to make a change.
Phil N3ZP
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
