Steve,
Check *ALL* the soldering with particular attention to those components
added or changed with the KXB3080 installation.
Check all the toroids for well tinned leads - particularly T2 and be
certain there is no short from solder buildup at the 'A' solder pad on
the KX1 board.
If there is a lot of solder on the solder pads, remove it. Many KX1s
that I repair suffer from 'solder overload' due to the use of a large
diameter solder (I use .015 inch diameter myself to allow good control
of the application amount).
73,
Don W3FPR
Steve Watkins wrote:
> All:
>
> I am in the process of doing receiver alignment on the KX1 after installing the 3080 module. I am unable to detect any peak on 40 meters during alignment, similar to what I heard during the basic KX1 receiver alignment, prior to installing the 3080 module. Does this indicate a problem with the 3080 module construction or installation?
>
> The 20 meter peaks are dicernable but not the 40 meter now?
>
> Thanks, Steve
> NE7RD
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
