Bruce,
What happens when you try it into a dummy load? What is the power
indication and what is the SWR indicated?
Put it into ATU CAL and try - what are the results?
Then put it into ATU TUN and try again - results?
Are resistors R3 and R4 swapped?
Remove the KXAT1 and measure the resistance between P1 pins 1 and 3 - it
should be zero.
Then put the KXAT1 back in and measure the resistance between the BNC
jack center conductor and lead 6 of T1 (the 1 turn winding) - you should
measure zero ohms if the connectors are mating properly.
73,
Don W3FPR
On 5/22/2013 8:58 PM, Bruce Ikefugi wrote:
> My KX1 seems to be working fine; I hear a strong signal into my other radios and no error messages or other problems. When I install the ATU I can null C9. When I tune, power always reads 0, sometimes for a second 1; R always equals 9.9. I am feeding to resonant antennas, a dipole on 14, an end fed on 7. R4 is at maximum. The same thing happens with the internal batteries or with a 13.5 power supply. I have checked my connections, soldering and toroids several times. Any suggestions would be very appreciated. I do not have a wattmeter or an swr meter. Thank you!
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
