As for crystal clear, I'll just say now, read the instructions
carefully on the crystals, since the GND wires are placed on the
sides not on the tops like you've seen in tons of stuff, and keep
some nice wires like off of LEDs or even your own bus wire for the
ground wires since the regular old resistor leads etc are often
copper plated and tinned soft iron and will want to stick to your
soldering iron tip. 73 de Alex NS6Y.
On Jun 3, 2006, at 4:11 AM, <
[hidden email]> wrote:
> Well the games have begun, I started building KX1 serial #001363
>
> It looked intimidating at first.; but yes, the instruction are
> crystal clear!! That's just what this reflector said.
>
> THIS WILL BE LOTS OF FUN...BTW my new HAKKO 936 from dayton sure is
> a pleasure to use.
>
> Ken K1UM
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
