Werner & Denise Haschke wrote:
> Forgot to mention I get the SCn with rit off and push and hold the rit
> button.
Hi Werner,
Before using scanning, you have to use the STO menu function to save
scan start/end points in frequency memories 1 and 2 (for each band).
Then, whenever RIT is off, you can activate scanning by holding CLR for
two seconds.
Scanning is “live” (not muted). It can be stopped by tapping a switch,
turning the VFO, or transmitting. If the VFO is set for 10 or 100 Hz
steps, scanning proceeds at 100 Hz per step. If the VFO is set for fast
tuning, scanning uses 1 kHz steps (if the receive mode is LSB or USB, 5
kHz steps are used outside ham bands).
73,
Wayne
N6KR
---
http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
