KX1 Trouble Shooting Help Needed

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

KX1 Trouble Shooting Help Needed

Jeff Hetherington-2
Hello Everybody.

We have reached the Alignment and Testing Part I as outlined in the manual.
It was very exciting when we turned on the LED and saw that bright glow.
Turning on the main power switch however was not as exciting (yet.)

There was no smoke, no burning smell or warm components, but there also was
no LED display.  The voltage checks all came out OK

Any suggestions as to where to begin ... or potential typical downfalls that
we may have stumbled onto.

Thanks.
73/72
  Jeff - VA3JFF
  Wendy - VE3TKS
  KX1 #631
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply | Threaded
Open this post in threaded view
|

Re: KX1 Trouble Shooting Help Needed

David Toepfer
These should be the big ones based on the schematic:

Make sure U1 is oriented correctly.

I would normally check the orientation of the resistor pack for the display,
but it looks by the pinout that it can be reversed with no ill effect (check it
anyway though, as I may be wrong).

U1 is powered by U8, so I would check that U8's orientation is correct.

Check for a positive voltage at the (+) terminal of C7 (not sure it is
installed yet, but I think it is) when the power switch is on (the light works
with the power on or off so it is no test of voltage going to the voltage
regulators with the power switch on).

Test of +5V at pin 20 of U1 with the power switch on.  

hope this helps

kb3ipe

dt
.
--- Jeff Hetherington <[hidden email]> wrote:

> Hello Everybody.
>
> We have reached the Alignment and Testing Part I as outlined in the manual.
> It was very exciting when we turned on the LED and saw that bright glow.
> Turning on the main power switch however was not as exciting (yet.)
>
> There was no smoke, no burning smell or warm components, but there also was
> no LED display.  The voltage checks all came out OK
>
> Any suggestions as to where to begin ... or potential typical downfalls that
> we may have stumbled onto.
>
> Thanks.
> 73/72
>   Jeff - VA3JFF
>   Wendy - VE3TKS
>   KX1 #631
> _______________________________________________
> Elecraft mailing list
> Post to: [hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft   
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com