Wait until you have the KXB3080 option installed and tested. Then check
with a 12 volt power supply to see if you have 3 watts output on all bands.
If less than 3 watts, install the power mod.
Do not install the power mod if you have at least 3 watts output on all
bands, it may overstress the output components by attempting to increase the
power output.
73,
Don W3FPR
> -----Original Message-----
>
> Hello all. I received KX1 SN 1721 several days ago. As of this
> evening, I have successfully completed Part 1 - both assembly and
> testing! I'm having a lot of fun with it, and looking forward to
> many fruitful hours of operation. Anyway, my question: I am
> building the 80/30 module to install from the beginning. Should
> I make the power mod now (it would be a whole lot easier than
> doing it later), or am I better off leaving it as is until it is
> completed so I can confirm low power out?
>
> Thanks for the help...I love reading the advice on this reflector!
> 73 de K6BQ
>
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.441 / Virus Database: 268.18.3/697 - Release Date: 2/22/2007
11:55 AM
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
