Oddly enough I tried a different power supply and it was OK. Then I
tried again the previous PS and it was OK. ?? I will check C44, however.
On 8/2/2011 2:41 PM, Don Wilhelm wrote:
> Casey,
>
> That can happen if C44 fails shorted. Turn the KX1 on and measure the
> voltage at the center of the BNC jack. If it is not zero, replace C44.
>
> 73,
> Don W3FPR
>
> On 8/2/2011 1:34 PM, NA7U wrote:
>> Is it normal for the KX1 to shut off if it sees a short across the BNC
>> connector (no RF applied)? I'm trying to use a 4:1 Guanella balun (which
>> looks like an electrical short) but the KX1 shuts off if it's in line. I
>> tested this behavior by simply shorting the BNC, also.
>>
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html