Jim -
I'm not sure this will help but here goes....
I have KX2 SN 11xx with current firmware loaded: uC 2.89, DSP 1.52.
I've reviewed all the update information and there doesn't appear to be
any changes that would modify the behavior of the DISP function. Mine
works as described on page 23 of the KX2 manual Rev. A5 dated May 28,
2916: Special VFO B Displays -- Tap the DISP button and rotate the OFS/B
knob to display the various parameters available. The "Log" function
was added in uC 2.77 and isn't covered in my manual version but works as
described in the Firmware Notes for that release.
You could consider reloading the firmware fresh from the Elecraft site
or call Elecraft support and pose the question to them.
73,
Brian, K0DTJ
On 7/7/2019 08:10, Jim Danehy wrote:
> I have owned my KX2 for some time now. I am now just now getting it on the
> air. I have a problem that I can not resolve. I have spent a few hours
> attempting to do that.
>
> When I try to bring up the DISPLAY function it does not work. The same
> button when held does work. Just the DISPLAY does not respond as it is
> supposed to do.
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
