Gene,
Only a possible guess.
You could try a direct Frequency Entry to a frequency in the 2 meter band.
Do it once with VFO A selected and then swap VFOs (A/B button) and do it
to that VFO as well.
73,
Don W3FPR
On 8/16/2014 5:21 PM, Gene Sochor wrote:
> I just completed the straightforward install of my new KX3-2M 2-meter
> module in my KX3 s/n 335 with ATU, encountering no issues. (firmware
> level at 2.12). The simple configuration setup procedure also went
> smoothly. After powering off and on as instructed, however, instead
> of a new 144 MHz band, I have now added a band which VFOA says is 22.0
> MHz, and VFOB is showing 44.0 MHz instead of 144.0. Restored the
> various settings as they were before the install, powered off and on
> again, then redid the 2 meter settings, with the same results. Has
> anybody else experienced this, or have suggestions?
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
