KX3 Extended Temperature Compensation Procedure - cannot start data collection

[orbarrett]

Hi all,

I successfully executed the steps in the KX3 Extended VFO Temperature Compensation Procedure, down to where PITCH was pressed to show the temperature compensation display (after the KX3 had been retrieved from the refrigerator, turned on and REF CAL was unlocked).


The temp. and freq. parameters were shown as expected, but when I tapped APF twice to start the data collection, nothing happened [SAVING did not appear on VFO B].  The prior Initial Reference Calibration procedure worked fine.


What might I be doing wrong?


Thanks!

Oliver Barrett  KB6BA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]