Thanks to all that replied, both to the list and privately. It looks as
though I misunderstood how long a charge was required. I have set it back
up to charge for 16 hours. Hopefully that will solve the problem. The
batteries worked fine from their initial charge so I think all will be well.
73,
Gary KJ7RT
Sun City, AZ
Fists #14460 NAQCC #3709
On Thu, Nov 29, 2012 at 2:06 PM, Gary Marklund <
[hidden email]> wrote:
> I just installed the KXBC3 in my KX3 SN 460. The batteries are Sanyo
> Eneloop XX 2400 mAH rechargeable NiMH batteries. I had charged them one
> time before installing on a NiMH specific charger. There was maybe a few
> hours of use on them. They were run down to the point where the rig shut
> down. As soon as I installed them in the KXBC3, I did a 4 hour charge to
> top them off. They indicated a full charge when I was done. I turned on the
> KX3 and the battery indicator showed a full charge but began an immediate
> slow discharge. Within a few minutes they hit the 8.5 V limit and the rig
> shut down. I've read and re-read the manual but do not see anything that
> I've done wrong. I've been running the KX3 on SLA batteries with no issues.
>
> Suggestions, Please!
>
> 73,
>
> Gary KJ7RT
> Sun City, AZ
> Fists #14460 NAQCC #3709
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
