KX3: Missing instructions for screws?

[Kevin Luxford]

When I finished the build of the KX3, there were a couple of small flat
head black screws left over.  I found a couple of spots where they
fitted, but for the life of me I could not find reference to them in the
assembly instructions.  These screws seem to go on either side of a male
connector visible in the window of a square cut-out on the top cover.
Further, I could find no reference to this 4 pin connector.  Has it
something to do with the yet un-released 2 m option and linear amplifier?

I have gone through both the assembly and operator's manuals at least
three times, however, this is no guarantee that I have not overlooked
the explanation I am looking for.

73
Kevin
VK3DAP / ZL2DAP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Kevin Luxford]

Thanks guys for the enlightenment.

I did not buy the paddle as I have BY1, an Accukeyer with a Kiwi
designed set of paddles, and a number of straight keys (my favourite
being the German WWII Junker DGBM key).  A poor excuse for not having
read EVERY word in the manuals including those bits which applied to
options not purchased.

Another case of, "Kevin, RTFM!"

Nice to get prompt solutions to problems at 2 am (my time.) Thanks again
Kevin
VK3DAP / ZL2DAP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Buck - k4ia]

Those holes are for the KXPD3 paddles - you can ignore them.  Elecraft
always gives you some extra hardware - just in case.

Buck
k4ia

On 8/7/2012 11:36 AM, Kevin Luxford wrote:

> When I finished the build of the KX3, there were a couple of small flat
> head black screws left over.  I found a couple of spots where they
> fitted, but for the life of me I could not find reference to them in the
> assembly instructions.  These screws seem to go on either side of a male
> connector visible in the window of a square cut-out on the top cover.
> Further, I could find no reference to this 4 pin connector.  Has it
> something to do with the yet un-released 2 m option and linear amplifier?
>
> I have gone through both the assembly and operator's manuals at least
> three times, however, this is no guarantee that I have not overlooked
> the explanation I am looking for.
>
> 73
> Kevin
> VK3DAP / ZL2DAP
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html