KX3 S/N 6624 Inopretive "Frequency/Tech-mode" -button

[Pentti A J Pajunen]

Yaw!

Dont recall when this malfunction started. I once asked for possible
causes and got a couple of good suggestions. The flat cable btwn Proc
and RF board should be checked. Ohm meter checked and found this cable
being intact. Gave slight spray to the base connectors, that also seem
OK as checked with magnifying googles. No bent pins, no obvious
oxidation. Bad button? Which point to check?

--
73 & CU Penna, OH2G, OH2CG
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]