I've been very successful using the rx I/q out for data modes with hrd. I
just have to remember to set it to DATA A when I want to xmit. I use a
separate usb sound card for the interface and have it selected in hrd as
such. Headphone out would get limited by volume and any filters where the
rx I/q is the raw output. There are also ways to run hdsdr on top of hrd as
well.
On Tuesday, December 9, 2014, Don Wilhelm <
[hidden email]> wrote:
> Dave,
>
> The KX3 I &Q outputs do not have sufficient amplitude to drive the
> soundcard levels required for soundcard DATA modes such as expected by
> DM-780.
> Use the headphone output.
> If you wish to run a Panadapter application such as NaP3, HDSDR or several
> other variations, then the use of the RX I/Q output are applicable, but not
> for soundcard data mode use.
>
> 73,
> Don W3FPR
>
> On 12/9/2014 9:55 PM, Dave Sublette wrote:
>
>> Has anyone used the KX3 with the Ham Radio Deluxe DM-780 digital software
>> package? I am trying to get the I&Q output to run the waterfall with no
>> success so far.
>>
>> Dave, K4TO
>>
>>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>
--
scott
[hidden email]
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
