KX3 and WSPR

[Jim Brown-10]

I just downloaded and installed WSPR and WSJT-X to run on my KX3. Both
work fine except that CAT control fails with WSPR. Both programs TX and
RX just fine using VOX for PTT. No change in the hardware setup -- I
quit WSJT-X and started WSPR. Tried it several times.

Both programs also work fine on my K3. The only difference in the setup
is that I'm using a real serial port to talk to the K3, and an
Elecraft-supplied KX3 to USB cable to talk to the KX3.

Any ideas?

73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Jim Brown-10]

On 4/22/2014 6:12 PM, Mike va3mw wrote:
> I think your serial port number has to be less then 8 or 16. I can't remember where the limitation is.

That was it.  Thanks!

73, Jim K9YC

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]