I would think anyone with an XG3 could use to do the extended VFO
calibration. I tested mine and it has reasonable accuracy and
stability. Of course I have a mw counter with E-11 accuracy for
checking this so I can just set the KX3 exactly to that frequency.
I have not run the KX3 thru frequency measurements so may have to do
that after trying the procedure recommended by Wayne. I run the KX3
on 28-MHz IF for 2m-FM so that mode is a good test of frequency
drift. I run the KX3 at 3w to drive my 2m-transverter.
When I have made these tests I will add the results to the
power-point review I made for the proceedings of MUD-2012. It is on
my website in pdf form:
http://www.kl7uw.com/Review_of_Elecraft_KX3.pdf73, Ed - KL7UW
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
