KXFL3 Adjustments

[AI4NS]

I am doing the alignment following the install, and I do not hear any
difference regardless of phase/gain, or preamp setting. There is also
no difference in S meter display either. I am using a piece of small
coax as the pickup antenna. Any suggestions?

Mike
AI4NS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]

[Don Wilhelm]

Mike,

I assume you are using the internal oscillator.  Do you have a 2 turn
loop on that 'piece of small coax'?  If not, you will not have a
sufficiently strong signal.

Set the menu values back to the defaults and try again.

73,
Don W3FPR

On 3/8/2020 10:49 PM, Mike Short wrote:
> I am doing the alignment following the install, and I do not hear any
> difference regardless of phase/gain, or preamp setting. There is also
> no difference in S meter display either. I am using a piece of small
> coax as the pickup antenna. Any suggestions?
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]