Hello group,
I am very close to pulling the trigger on a KX3 and possibly the
KXPA100/KXAT100 combo. If I can swing the KXPA100/KXAT100 I think I
would not option the KX3 with the KXAT3 at this time. But I have some
questions.
The manual mentions that with the amp enabled but the power set to below
10W that the amplifier passes the RF through without amplification. If
this is the case has anyone measured the current draw of the KXPA100 in
this mode with just the tuner working?
Also, has anyone measured power consumption at less than full power, say
25W, 50W? Not sure how bad the efficiency gets as the power out goes down.
Gary Mitchelson
NC3Z Davidsonville, MD FM18
http://www.mitchelson.org/______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
