Tom,
While I do not have an IC-7600 I do use an IC-7610 with a KPA500; the cable
should be the same.
I use a DIY band data cable to connect the IC-7610 to the KPA500 and it has
worked for almost three years.
I'm curious as to the exact part numbers of the cables you purchased from
the two different vendors.
What are the vendor names?
Do you have a schematic diagram of either/both cables?
If you are interested, I can send you a schematic of the cable I built.
73,
Ken
WA2LBI
On Sat, Mar 27, 2021 at 2:43 PM Tom Ewing via Elecraft
<
[hidden email]>
wrote:
>
> Good day, and thanks for reading.
>
> My newly acquired KPA500 doesn’t want to play with my IC-7600.
>
> In operate mode when I key the radio, the LEDs on the KPA500 display solid
> into the yellow, and there is no output. The amp is not faulting.
>
> I’m using an Icom 7 pin DIN cable (two actually from two different
> vendors) and tried two different radios, both IC-7600s with the same
> result.
>
> In the KPA menus, I have set the “radio” option to “analog”.
>
> Am I missing something else?
>
> Thanks in advance.
>
> Tom
> W0XXX
>
>
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]
Locked
