LCD Problems

[Fabs-2]

Hello,

I'm from french part of Switzerland so sorry for my english :) I have
some problems with the LCD from the K2. I have set up the control board,
front panel et some stuffs froms de RF boards and when I plug the K2 the
relays are inizialised, I have de back light on the LCD but nothing
appears on it. I read the troubleshooting but I think that all is ok.

Have you some ideas ?

Tnx Fabs
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[G3VVT]

Fabs,
 
Check that you have soldered pin 1 on U1 the display driver IC on the Front  
Panel PCB. Can be fixed without removing the LCD with care.
 
Bob, G3VVT
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Fabs-2]

That's it Bob ! TNX a lot !

Fabs

[hidden email] wrote:

> Fabs,
>  
> Check that you have soldered pin 1 on U1 the display driver IC on the
> Front Panel PCB. Can be fixed without removing the LCD with care.
>  
> Bob, G3VVT


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com