Hello Craig,  Just tested my setup and its working fb, so can give you my settings. Only difference is that I have a "navigator interface in between the LP-Pan and the EMU-202. But with the right settings you should be good.
First you have to setup your K3 for digital. Press the mode key on the right to get " TX Data " on the right hand side of the screen. Then press the "AFX" key until "Data A" comes up. Also set the "mic" level to about 25 for a starter. That should do for the K3 settings. If the K3 isn't set for the digital it won't work(software).
Now now I have to jar my memory for this part. But lets leave this for last....
Open up Mixw. And click on "configure." In "trcvr/Cat/Ptt" set the "cat and model" to K3/k2. Then click on the "details " button and set the "port and Buad rate"(baud rate is same as K3 baud rate. Rest is Data bits 8, parity none, stop bits 2, and "always off" on both. Close that screen.
Nest go to "secondary push to talk port" Go to Port settings. "port number" Data bits *, parity none, stop bits 2, rts-ptt, dtr- always off.close secondary port. To find the port numbers and assignments go to "device manager" and open comports.
Now go to the "sound device settings. In the first box set to internal/external sound card.
In the "input and output" boxes set it to the emu 202 card for "mic and speaker emu 202.
Close the box.
You should be pretty close now. When you open mixw make sure that the mode is set to "psk" or "rtty". Also check that the k3 is showing "TX data" on the right hand side of the screen and that "afx" is set to "data a".
Now if it doesn't work or xmit, I would take two I/8 audio cables and connect them to the in and out audio connections on the K3 and sound card on the PC. But if you see the "emu-202 on the first setup you should be good.
When the k3 starts to xmit, you will see 4 bars over the "alc" on the screen. If there are more set it with the mic button to see "4 bars".
I hope I have it all. But if I don't we have the week-end to get it squared away.
Don....w2xb
Date: 10/16/09 19:54:56
Subject: RE: LP-PAN & EMU-0202 and MixW digi software on my K3
Don,
Yes I do…. Please let me know what I can do. The best time for me would be Sunday afternoon after noon Colorado time. Also please let me know what cables I need so I can get them tomorrow.
73's
Craig Turner WØLV
PO Box 75774
Colorado Springs, COÂ 80970
719-473-6398
From: W2XB (via Nabble) [mailto:[hidden email]]
Sent: Friday, October 16, 2009 2:16 PM
To: Craig WØLV
Subject: Re: LP-PAN & EMU-0202 and MixW digi software on my K3
Hello Criag,
I am using the LP-Pan and k3 with mix for all modes.do you still need help setting up? if so let me know and will work with you over the weekend.
Don...w2xb
I have all of the above. Is there any way I can use the LP-Pan and sound card to run with MixW for digi modes on my K3. I have no idea how to configure. Any help would be VERY much appreciated.
Thank all of you in advance!!!!!!
Craig WØLV
| 
Locked
faint_grain.jpg (1K)