N6XI:
>I have also set up Mn for each band as follows:
M1 - CW
M2 - SSB
M3 - RTTY
>Thus, once I am on a band I can change mode (and frequency, filters, etc.)
with two taps. I use M4 as a temporary scratchpad. I may revert M3 to that
purpose as well since I don't operate much RTTY.
Sounds neat Rick. Another use I'll have for Mn will be to
set up diversity receive using the Sub RX.
This requires assigning my TX antenna to Main, assigning
my RX antennas to Sub, assigning both receivers plus
RX settings (BW, etc) to the same VFO, Main audio to
left and Sub audio to right including AF gain settings.
I was thinking about a similar Mn setting for
"Split" but see it's already included on the front panel.
Ed W0YK tells me you are carefully thinking through all
the parameters that should be included in the Mn settings
(e.g. audio channel assignments, etc.)
If Elecraft will hurry up and get our units
shipped I think you'll get a lot of "help" from some
of us...including some you may not want! :-)
73, Bill W4ZV
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
