Hi John,
I recently had a very similar problem. In my case, all bands were
putting out over 100 W except I could only get 90 W on 30m into a dummy
load. I counted & recounted (& recounted!) the turns of the
corresponding toroids and double checked that I hadn't mixed up
capacitors in the those low pass filters. Everything checked out so I
wasn't sure what to do next. In semi-desperation I recalibrated...and
then everything checked out, all bands over 100 W. Before trying that
you might first double check that you're getting correct output without
the 100 W stage, >= 10 W on 10/12m and >= 15 W on the rest if I recall
correctly.
Good luck! (And please post your solution when you find it)
Mike AB3AP
[hidden email] wrote:
> [...] I have completed K2/100 #4891 and my power output on 20m and 30m is
> lower than expected : 80 watts on 30m and 55 watts on 20m. Power
> output on all other bands is as expected. The receiver sounds OK on
> all bands.
>
> Any suggestions please?
>
> Thanks
>
> John, G4IRN.
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
