I'm getting 100 watts out with 100 watts requested, 120 watts out with
120 watts requested.
73,
Ken K3IU
K0EKL wrote:
> After doing the full calibration multiple times (Synthesizer/Wattmeter/TX
> Gain/ and TCXO) I find that I have lower than expected power output on 6m.
> Firmware is 1.78 and I have the rig set to transmit through the 2.8 KHz
> filter.
>
> With the K3's power set to 100 watts I'm seeing 66.3 watts output to a dummy
> load on my LP-100A wattmeter. Set to 120 watts I see a maximum of 76 watts.
> Is this normal behavior?
>
> Thanks.
>
>
> _______________________________________________
> Elecraft mailing list
> Post to:
[hidden email]
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>
http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help:
http://mailman.qth.net/subscribers.htm> Elecraft web page:
http://www.elecraft.com>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
