MD-2 Micrphone

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

MD-2 Micrphone

Tom Mc
I took advantage of the reduced prices and ordered the MD-2 and CB-1
microphone and base for my K2.  They arrived and certainly look and feel
very nice, but no surprises there.

I have a couple of questions, anyone can be of help with them, I appreciate
hearing from you:

1)    I also have the Elecraft/Heil hand mic and was able to install the
5.6k resistor into the mic plug, rather than into the K2.  This worked out
fine and now I can use other mics and data sources (I use a RigBlaster for
psk31)with the K2.  Has anyone tried to put the 5.6k resistor into the plug
of the MD-2 and is their anything special I should know?

2)   I seem to have an 'extra' part that came with the order.  It is a piece
of metal about 3/4 inch long, threaded with standard screwdrivers slots at
each end.  It's not immediately obvious to me were this goes.  (And I forget
if it came with the microphone or the base.)

3)  I really like the idea the there is a  the jack for a footswitch.  Does
anyone have a source where I can pick up a switch?

4)  Also, along the same lines as the footswitch, is there an 'always on'
position on the PTT switch on the mic ?(I haven't actually used the mic yet
because I haven't yet installed the resistor).

Thanks for your help and have a nice holiday season,

Tom McCulloch
WB2QDG
k2 1103

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com