MD2 Mic

[Tom Mc]

Has anyone tried placing the 5.6k resistor for the MD2 microphone into the
plug or into the microphone itself (rather than into the K2)?

I've done this with the hand mic with success, but the MD2 plug seems a lot
more crowded and a few pins have heat shrink, which I'd rather not remove.

Happy Holidays

Tom, WB2QDG
K2 1103

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[K5JAZ-2]

Hi Tom. I did this mod this weekend without any problems. I partially removed
the heatshrink where required, soldered, and put a single layer of plastic tape
around all pins before reassembly.
--
Regards,
Jim Brown, K5JAZ

 -------------- Original message ----------------------
From: Tom Mc <[hidden email]>
> Has anyone tried placing the 5.6k resistor for the MD2 microphone into the
> plug or into the microphone itself (rather than into the K2)?
>

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com